Steps to Replace a Light Fixture

• Turn Off Power at the Breaker:

  • Switch off the circuit breaker for safety.
  • Use a voltage tester to ensure no power is flowing to the fixture.

• Remove the Old Fixture:

  • Unscrew any covers or decorative parts to access the mounting hardware.
  • Disconnect the fixture from the electrical box by removing screws or nuts.

• Disconnect the Wires:

  • Pull down the fixture to access the wiring.
  • Remove the wire connectors and disconnect the old wires (black, white, and ground).

• Prepare the New Fixture:

  • Check the manufacturer’s instructions for installation details.
  • Strip about 1/2 inch of insulation from the new fixture’s wires if necessary.

• Attach the Mounting Bracket (if required):

  • Install the mounting bracket to the electrical box using screws if your new fixture has one.

• Connect the Wires:

  • Match the fixture wires to the electrical box wires:
    • Black (hot) to black wire
    • White (neutral) to white wire
    • Green or bare copper (ground) to the ground wire or screw

• Secure the Fixture:

  • Push the wires back into the electrical box.
  • Attach the new fixture to the mounting bracket or directly to the electrical box.

• Install Light Bulbs and Cover:

  • Insert the bulbs and attach any decorative covers or shades.

• Turn Power Back On and Test:

  • Restore power at the breaker.
  • Test the fixture to ensure it works properly.

• Adjust or Secure as Needed:

  • Tighten any screws if the fixture wobbles or is uneven.